1500 rmp 1800rmp 650 KVA Standby Diesel Generator
Diesel generator set from 18 to 1320 kW; Cummins engine; Leroy somer or Stamford alternator; Factory price and factory outlet; CE/ISO and BV/TUV/SGS verified; OEM and ODM manufacturer; ...
50Hz,400/230V, 3 phases and 4 wires
Engine Brand & Model
Alternator Brand & Model
Standard Noise Level@7m (Soundproof Sets)
Circuit Breaker Type
3 Poles MCCB
Frequency & Phase
50Hz, 3Phases + 4Wires
Engine Speed (RPM)
Fuel Consumption (L/hr)
Dimensions and Weights
Engine Brand & Model: Cummins KTA19-G8
Standard Cummins Engine Data
No. of Cylinders
6 in line type
Gross Engine Power(kW)
Bore / Stroke
Radiator fan cooling
24V DC motor
Coolant capacity, including radiator (L)
15W40-CF4 or above grade
Lube System Capacity(L)
How to clean the cooling system:
◇Use eau douce to clean the cooling system;
◇If there is a drainage valve, close it or connect the coolant pipe;
Note: In order to avoid producing air pocket, and the speed of intake coolant could not be over 19 L/min.
◇Inject the mixture of water and cleaner into cooling system. Consult the manufacture 's direct, close the cover;
◇Start the engine, running the genset without any load for 30 minites, and wait the coolant temperature reach to 82 ℃(180℉).
◇Stop the engine, after it has been cold, loosen the cover of cooling system and depress its pressure. Take off the cover, open the drainage valve (if there is), or take off the coolant pipe at the bottom, so that the coolant can leak out from cooling system, and use eau douce to clean the cooling system, then close the valve or connect the coolant pipe.
How to add coolant:
◇Inject the right coolant to the cooling system via the injector, but don't cover the injector.
◇Start the engine, and keep idle running for1 minute so as to discharge all the air among the gaps, and then stop it.
◇Check the coolant level and keep it equal the bottom of the injector.
◇Clean the cover of the injector, and check its gasket. If the gasket gets out of work, the cover needs to be replaced. If the gasket can work, please use right PRESSURE INSPETING TOOL to inspect the injector cover and check if it meets the required pressure marked on the cover. If it can't meet, please replace to new injector cover.
◇Start the engine, check the cooling system whether any leak occurred, and whether the runing and temperature on good condition.
The safe and protective equipment must be installed when install gas generator set, to protect the personal and matterssafety. The protective panel should be installed for revolving parts or moving parts. The heat insulating equipment should be installed for high temperature parts to ensure the safety of operator.
All engines are designed with crankcase breather and exhaust pipe to discharge the gas of crankcase, lower the pressure of crankcase. Please check if the installing position of crankcase breather and exhaust pipe are right or faulse before genset operation.
Cooling system clutch and connection:
When the engine is still operating or water temperature is still very high, please don't loosen the clutch. Because the pressure of cooling system is very high, if the clutch is loosen, high temperature water will be sprayed out and cause seriously scald. After the engine and water cool, heat exchanger, thermometer box and radiator clutch can be open. In order to ensure the person and genset safety, please change the problematic and aged pipes timely.