50 KW Biogas Generator
Ratings *Ratings at 0.8 power factor Performance Data * The above fuel consumption is calculate with the natural gas whose heat value is 35.8MJ/Nm 3 Dimensions and Weights Engine Brand & Model: HG6B Engine Data How to clean the radiator: Examine the radiator, check whether there is any...
50Hz, 380/220V, 3 phases and 4 wires
*Ratings at 0.8 power factor
Engine Brand & Model
Alternator Brand & Model
Standard Noise Level@7m (Soundproof Sets)
Circuit Breaker Type
3 Poles MCCB
Frequency & Phase
50hz 3Phases + 4Wires
Engine Speed (RPM)
Fuel Consumption (Nm3/hr) 100% Load
* The above fuel consumption is calculate with the natural gas whose heat value is 35.8MJ/Nm3
Dimensions and Weights
Engine Brand & Model: HG6B
No. of Cylinders
Bore * Stroke (mm)
102 * 120
24V DC motor
Coolant capacity, including radiator (L)
15W40-CF4 or above grade
Oil pan capacity (L)
How to clean the radiator:
Examine the radiator, check whether there is any broken for thermal fin, and if there is any eroding, dust, hexapod, leaves, oil dirty or other scraps; If it is necessary, clean the outside of the thermal fin.
While use the high pressured air to clean, please ware the protection veil and protection clothes.
The biggest pressure of injection nozzle should not be less than 206KPa(30 psi); Use high pressured air to clear the impurity, the air flow orientation should be opposite to the fan blowing. The distance of nozzle and thermal fin is about 6mm(0.25 inch), so that the air flow is parallel with the pipe. Moving the nozzle slowly, and the dust between pipes will be cleared. It is also possible to clear the thermal fin via high pressure water flow, and the biggest pressure should be not less than 275KPa(40 psi); the distance of nozzle and thermal fin should not be too close, or it will break the thermal fin. Use the high pressure water flow to intenerate dusts, and clean it from two side.
About oil clearing, we can use oil remove and steam, then use washing power and hot water clean from two sides of thermal fin. After that using eau douce to clean the themal fin, start the engine, make it running at high speed and without load. It can make the engine washed parts to be dried fastly.Then close the engine and use a light to check the cleanliness condition, if not, it could be cleaned again.
Examine the thermal fin whether there is any broken and check the jointing, installation, connection and pressurizing condition. If necessary, it must be repaired.
Move and hoist generator set:
◇Advice to use hemp rope, so that it can aviod to damage genset
◇Be careful and don't let hemp rose touch sensitive parts
◇Check if all force point have welding shortage or loosening bolt
◇Check all relative structure to ensure all support or equipment can bear the weight over 10% of genset
◇Ensure the balance of equipment when hoist generator set
◇There must be no people stand under the hoisting equipment
◇Don't hoist equipment over height
Excess alcohol and medicines:
As for any operator or other persons, who is not allowed to operate generator or stay around genset in the situation of drinking alcohol or have medicines.
Please take good fire preventive measures according to the local law and regulations. The fire extinguisher should be easy to get to. Emergency lamp and safe exit should be designed according to the national fire preventive requirement.